Strip Footing Calculation Spreadsheet
Category: RESOURCES
Reinforced Concrete Design Using The Ultimate Limit Design Method Spreadsheet
Design Of Typical Floor Roof Section Accordin to BS Spreadsheet
Retaining Wall Masonry Design and Calculation Spreadsheet
Retaining Wall Masonry Design and Calculation Spreadsheet
A traditional gravity masonry retaining wall uses the mass of the brickwork/masonry to retain the earth behind it.
It can be built using a number of materials. The mass or weight of the bricks or blocks will determine the size of the wall required.
Design Of Septic Tank Followed By Anaerobic Filter Spreadsheet
Torsion Irregularity Calculation and Check Spreadsheet
Septic Tank Design And Calculation Spreadsheet
Septic Tank Design And Calculation Spreadsheet
A septic tank is an underground chamber made of concrete, fiberglass, or plastic through which domestic wastewater (sewage) flows for basic treatment.
Settling and anaerobic processes reduce solids and organics, but the treatment efficiency is only moderate (referred to as “primary treatment”).
Septic tank systems are a type of simple onsite sewage facility (OSSF).
They can be used in areas that are not connected to a sewerage system, such as rural areas. The treated liquid effluent is commonly disposed in a septic drain field, which provides further treatment. Nonetheless, groundwater pollution may occur and can be a problem.
The term “septic” refers to the anaerobic bacterial environment that develops in the tank that decomposes or mineralizes the waste discharged into the tank.
Septic tanks can be coupled with other onsite wastewater treatment units such as biofilters or aerobic systems involving artificially forced aeration.
The rate of accumulation of sludge—also called septage or fecal sludge—is faster than the rate of decomposition.Therefore, the accumulated fecal sludge must be periodically removed, which is commonly done with a vacuum truck.
Thermal Effects For Steel Building Or Structure Calculation Spreadsheet
Thermal Effects For Steel Building Or Structure Calculation Spreadsheet
This spreadsheet is a program written in MS-Excel for the purpose of considering the thermal effects for a
steel building or structure. Specifically, the appropriate maximum design temperature change, the change of
length or stress as applicable, and the maximum building or structure length either without or between expansion
joints is determined. There is also a “General Thermal Effects Calculator” which can be used to selectively
determine any of the analysis parameters, as well as a temperature converter which can be used to convert from
oC (Celsius) to oF (Fahrenheit).
